User Tools
group_secar2.0
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
group_secar2.0 [2018/09/13 14:31] plastun |
group_secar2.0 [2018/09/13 14:32] plastun |
||
|---|---|---|---|
| Line 100: | Line 100: | ||
| ENDLOOP;'' | ENDLOOP;'' | ||
| - | Number of rays in another planes | + | Rays in another planes |
| - | '' | + | '' |
| - | SRAY:= 0.0;\\ | + | SRAY:= 0.0; |
| SRDE:= 0.0;'' | SRDE:= 0.0;'' | ||
| Created loop for target position. Observed piece-wise curve for resolution vs target offset (see figure below) in case of 4th order calculation. If order reduced to the 1st, than curve is smooth, but maximum resolution is shifted. | Created loop for target position. Observed piece-wise curve for resolution vs target offset (see figure below) in case of 4th order calculation. If order reduced to the 1st, than curve is smooth, but maximum resolution is shifted. | ||
| {{ : | {{ : | ||
/srv/thewikis/JIOSS/data/pages/group_secar2.0.txt · Last modified: 2018/09/13 16:49 by plastun
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
