This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
during_experiments [2017/06/17 14:50] pereira [Efficiency of OBJ Scintillator] |
during_experiments [2023/07/20 10:43] swartzj |
||
---|---|---|---|
Line 23: | Line 23: | ||
* Set the trigger to S800 singles and downscale factor 1 | * Set the trigger to S800 singles and downscale factor 1 | ||
- | * On PanelMate, open page 4 in S800DRIV | + | |
- | * Click on "upstream mask" | + | |
+ | |||
+ | | ||
* Start a run without taking to disk and look in the S800 SpecTcl at the 2D xy position spectrum of (s800.fp.crdc1.x, | * Start a run without taking to disk and look in the S800 SpecTcl at the 2D xy position spectrum of (s800.fp.crdc1.x, | ||
Line 31: | Line 33: | ||
{{: | {{: | ||
- | * Remove | + | * Remove |
- | * Repeat the procedure with CRDC2 by inserting the "downstream mask" | + | * Repeat the procedure with CRDC2 by inserting |
* {{: | * {{: | ||
Line 98: | Line 100: | ||
At relatively high rates (~0.5 MHz), the OBJ scintillator will be gradually damaged. Experimenters should check the efficiency of this detector continuously during the course of the experiment. Whenever the rates drop below ~90%, they may request the Device/Beam Physicist to shim the detector. | At relatively high rates (~0.5 MHz), the OBJ scintillator will be gradually damaged. Experimenters should check the efficiency of this detector continuously during the course of the experiment. Whenever the rates drop below ~90%, they may request the Device/Beam Physicist to shim the detector. | ||
- | Before shimming, make sure that the thresholds are set properly (not too high). | + | |
+ | |||
+ | Before shimming, make sure that the thresholds are set properly (not too high) (refer to section " | ||