Differences

This shows you the differences between two versions of the page.

--- electronics [2013/10/31 09:26]
pereira old revision restored (2013/10/24 10:49)
+++ electronics [2013/10/31 09:26]
pereira
@@ Line 12: / Line 12: @@
 The main purpose of the trigger is to implement a coincidence between the S800 focal plane and a secondary detector principally located at the target location. The trigger logic is implemented in a LeCroy 2367 Universal Logic Module (ULM) by means of its XC4000E Xilinx FPGA. One of the main advantages of this module are:
-  * The reduction of cabling and number of modules involved in the implementation of the trigger logic.
+  -  The reduction of cabling and number of modules involved in the implementation of the trigger logic.
-  * The possibility to remotely control and inspect trigger signals, even while beam is present in the vault.
+  -  The possibility to remotely control and inspect trigger signals, even while beam is present in the vault.
-  * The possibility to save and restore the trigger configuration at any time.
+  -  The possibility to save and restore the trigger configuration at any time.
 The trigger schematic is shown on the Graphical User Interface (GUI) displayed in the figure below.

S800 Documentation