gas_handling_system
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
gas_handling_system [2013/12/26 14:51] pereira [In the S3 vault] |
gas_handling_system [2013/12/26 14:54] pereira [Removing Gas from Focal Plane Detectors] |
||
|---|---|---|---|
| Line 84: | Line 84: | ||
| * Follow instructions under [[# | * Follow instructions under [[# | ||
| - | * Monitor the pressure of the focal plane vacuum chamber (as read out via the I264IG ion gauge in PanelMate **S800vac.MT2 page 07**) while detectors are being filled with gas; the pressure normally stays below 5E-5 Torr. | + | * Monitor the pressure of the focal plane vacuum chamber (as read out via the I264IG ion gauge in PanelMate **S800vac.MT2 page 07**) while detectors are being filled with gas; the pressure normally stays below 5 x 10< |
| * Confirm that the detector pressure as indicated by the display labeled P.T. #2 reads below a couple of Torr | * Confirm that the detector pressure as indicated by the display labeled P.T. #2 reads below a couple of Torr | ||
| Line 148: | Line 148: | ||
| * Open **valves 6 and 22** | * Open **valves 6 and 22** | ||
| - | * Enter vault and close main valves on gas bottles: | + | * Enter S3 vault and close main valves on [[# |
gas_handling_system.txt ยท Last modified: 2023/05/11 11:29 by pereira
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
