installation_fp_sci
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
installation_fp_sci [2015/05/04 12:33] pereira [Installation of FP scintillator] |
installation_fp_sci [2015/05/04 12:47] pereira [Installation of FP scintillator] |
||
|---|---|---|---|
| Line 18: | Line 18: | ||
| ==== Installation of FP scintillator ==== | ==== Installation of FP scintillator ==== | ||
| - | In the figure below, the FP scinitllator can be seen on the left side of the hodoscope | + | - The figure below shows the FP chamber open, with the " |
| + | - Unplug the bases of the up and down phototubes. The platic tie holding the cable of the up phototube to the chamber needs to be cut | ||
| + | {{: | ||
| + | - Unscrew the two bolts holding the scintillator frame to the chamber {{: | ||
| + | he first step to do is unplugging the up and down bases of the phototubes | ||
| + | In order to remove the " | ||
| Click Vent status [start pumpdown] --> vent status= pumpdown in progress (blue) | Click Vent status [start pumpdown] --> vent status= pumpdown in progress (blue) | ||
installation_fp_sci.txt · Last modified: 2023/08/18 10:19 by noji
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
