installation_fp_sci
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
installation_fp_sci [2015/05/04 13:05] pereira [Closing focal-plane chamber] |
installation_fp_sci [2015/05/04 13:07] pereira [Closing focal-plane chamber] |
||
|---|---|---|---|
| Line 35: | Line 35: | ||
| - When the chamber is almost close, turn the know to close the clamps | - When the chamber is almost close, turn the know to close the clamps | ||
| - Before pumping the chamber down, make sure that the scintillator is properly connected. This can be done by biasing the detector and checking the signals, either from the scalers or with a scope. One should clearly see cosmic rays; if that is not the case, the phototubes are likely miss connected | - Before pumping the chamber down, make sure that the scintillator is properly connected. This can be done by biasing the detector and checking the signals, either from the scalers or with a scope. One should clearly see cosmic rays; if that is not the case, the phototubes are likely miss connected | ||
| - | - In order to pumpdown the chamber, make sure that the manual vent valve is closed | + | - In order to pumpdown the chamber, make sure that the manual vent valve is closed. Start manual pump to get a pressure below 50 mtorr {{: |
| - | - Start the manual pump to get a pressure below 50 mtorr {{: | + | - Close the manual pump; open PanelMate **S800vac** and go to page 07. Click on window **PUMPDOWN STATUS** |
| - | - | + | |
| - | - | ||
installation_fp_sci.txt · Last modified: 2023/08/18 10:19 by noji
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
