Differences

This shows you the differences between two versions of the page.

--- nmr_probes [2023/05/09 15:06]
noji [Description]
+++ nmr_probes [2023/10/24 08:17]
noji wish is now wish8.6
@@ Line 15: / Line 15: @@
 and typing, for the analysis line dipoles
-  $ /usr/bin/wish /srv/s3-nmr/analysis/analysis.tcl
+  $ /usr/bin/wish8.6 /srv/s3-nmr/analysis/analysis.tcl
 and for the spectrograph dipoles
-  $ /usr/bin/wish /srv/s3-nmr/spectrograph/spectrograph.tcl
+  $ /usr/bin/wish8.6 /srv/s3-nmr/spectrograph/spectrograph.tcl
-Sometimes the initialization of these applications fail. In that case check section [[nmr probes#troubleshooting|"Troubleshooting"]] below). The picture below shows the NMR panel for the S800 Analysis Line GUI as an example. The top (yellow) panel shows the data relevant to the NMR module, the middle (pink) the digitized signal from the oscilloscope and the bottom (blue) the status and measurements for the dipoles.
+**Note that it is not simply wish anymore but wish8.6.**
+Now press start on the GUI, which is shown below, and you should see a field reading. Sometimes the initialization of these applications fail. In that case check section [[nmr probes#troubleshooting|"Troubleshooting"]] below). The picture below shows the NMR panel for the S800 Analysis Line GUI as an example. The top (yellow) panel shows the data relevant to the NMR module, the middle (pink) the digitized signal from the oscilloscope and the bottom (blue) the status and measurements for the dipoles.
 {{:wiki:NMR-control.jpg?350|NMR Control panel for the Analysis line dipoles.}}

S800 Documentation

User Tools

Site Tools

Differences

Page Tools