This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
preparation_for_tuning_the_s800 [2013/12/14 16:30] pereira |
preparation_for_tuning_the_s800 [2013/12/14 17:54] pereira |
||
---|---|---|---|
Line 7: | Line 7: | ||
* [[Turning magnets on/off]] | * [[Turning magnets on/off]] | ||
* [[Magnetic-rigidity setting]] | * [[Magnetic-rigidity setting]] | ||
- | + | * [[To-Do list for the preparation | |
- | + | ||
- | PREPARATION FOR TUNING | + | |
- | In S3 vault | + | |
- | Arm dump switches | + | |
- | Make sure object ion gauge is off | + | |
- | Go to page xx on Panel Mate xxx. Check status xxx | + | |
- | | + | |
- | Make sure gas bottles for FP detectors are open | + | |
- | Make sure Intermediate PPACs have gas | + | |
- | + | ||
- | In data-U | + | |
- | Start Software tools | + | |
- | PanelMates | + | |
- | NMR GUIs | + | |
- | Barney | + | |
- | Labview Gas Handling System Controls | + | |
- | Labview Bias Controls | + | |
- | Alarm servers and monitors | + | |
- | Linux HV controls (alarm server should be started first) | + | |
- | SpecTcl (alart server should be started first) | + | |
- | Run Control (in coordination with experimenters) | + | |
- | Trigger Control GUI (in coordination with experimenters) | + | |
- | Scalers (in coordination with experimenters) | + | |
- | Put 10 Amps in Spectrograph dipoles | + | |
- | + | ||
- | Start gas in detectors | + | |
- | Refer to Section xx (S800 Focal Plane Gas Handling System Operation) | + | |
- | + | ||
- | Enable crad04 with a rate limit of 20 kHz (crad04 looks at E1 up) | + | |
- | If it does not interfere with experimenter | + | |
- | Set spectrograph Brho | + | |
- | Start scalers | + | |