This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2015/10/26 15:46] pereira |
s800_daq_tools [2015/10/27 07:25] pereira [S800 Software tools] |
||
---|---|---|---|
Line 4: | Line 4: | ||
* [[#Run Control Window]] | * [[#Run Control Window]] | ||
* [[# | * [[# | ||
+ | * [[#Mesytec CFD GUI]] | ||
* [[#Delay Window]] | * [[#Delay Window]] | ||
* [[#Trigger GUI]] | * [[#Trigger GUI]] | ||
Line 37: | Line 38: | ||
The EventBuilder window will appear as part of starting the [[s800 daq tools#run control window|Run Control]]. This window will communicate statistics such as number of buffers read and number of events broadcast, and will also show error messages, should they occur. | The EventBuilder window will appear as part of starting the [[s800 daq tools#run control window|Run Control]]. This window will communicate statistics such as number of buffers read and number of events broadcast, and will also show error messages, should they occur. | ||
+ | |||
+ | ==== Mesytec CFD GUI ==== | ||
+ | The S800 electronics includes a Mesytec CFD (MCFD), used to " | ||
+ | |||
+ | The MCFD GUI is invoked by either clicking the icon **MCFD GUI** in the desktop of [[Software# | ||
+ | |||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | ||
+ | * Alternatively, | ||
+ | * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a " | ||
+ | * After modifying any of the CFD parameters, click **Commit to Device** | ||
+ | * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | ||
+ | |||
+ | |||
==== Delay Window ==== | ==== Delay Window ==== | ||
+ | {{: | ||
+ | |||
+ | |||
+ | |||
- | {{: | ||
This window appears when the " | This window appears when the " |