Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
s800_daq_tools [2015/10/26 16:59] pereira [Delay Window] |
s800_daq_tools [2015/10/26 17:00] pereira [Delay Window] |
| |
| |
{{:wiki:482px-Runcontrol.png|Run Control Window}} | {{:wiki:mcfd16gui.jpg|MCFD GUI}} |
| |
| |
| ==== Delay Window ==== |
| {{:wiki:482px-Runcontrol.png|Run Control Window}} |
| |
| |
| |
==== Delay Window ==== | |
| |
{{:wiki:mcfd16gui.jpg|MCFD GUI}} | |
| |
This window appears when the "Init" button is pressed on the VME crate controller tab as part of the initial setup of the [[s800 daq tools#run control window|S800 USB daq]]. It can also be accessed by pressing the "Show GUIs" button. The delay module allows software configurable delays to be applied to each of the signals indicated in the Channel column, which then form the TDC stops. It is configurable to enable delays to be set with beam on target, as the needed delay may change depending on experimental conditions. | This window appears when the "Init" button is pressed on the VME crate controller tab as part of the initial setup of the [[s800 daq tools#run control window|S800 USB daq]]. It can also be accessed by pressing the "Show GUIs" button. The delay module allows software configurable delays to be applied to each of the signals indicated in the Channel column, which then form the TDC stops. It is configurable to enable delays to be set with beam on target, as the needed delay may change depending on experimental conditions. |