This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2015/10/27 07:18] pereira [Mesytec CFD GUI] |
s800_daq_tools [2015/10/27 07:21] pereira [S800 Software tools] |
||
---|---|---|---|
Line 4: | Line 4: | ||
* [[#Run Control Window]] | * [[#Run Control Window]] | ||
* [[# | * [[# | ||
+ | * [[#MCFD GUI]] | ||
* [[#Delay Window]] | * [[#Delay Window]] | ||
* [[#Trigger GUI]] | * [[#Trigger GUI]] | ||
Line 48: | Line 49: | ||
* To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | ||
- | + | * Alternatively, | |
- | | + | |
* By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a " | * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a " | ||
- | + | | |
- | | + | |
- | + | ||
- | * After adjusting the thresholds, the new configuration must be saved in file **MCFD16.tcl** in directory **/ | + | |
* The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | ||