S800 Documentation

User Tools

Site Tools

Trace:
s800_daq_tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
s800_daq_tools [2015/10/27 07:18]
pereira [Mesytec CFD GUI] 		s800_daq_tools [2015/10/27 14:13]
pereira [Delay Window]
Line 4: Line 4:
     * [[#Run Control Window]]     * [[#Run Control Window]]
     * [[#EventBuilder Window]]     * [[#EventBuilder Window]]
 +    * [[#Mesytec CFD GUI]]
     * [[#Delay Window]]     * [[#Delay Window]]
     * [[#Trigger GUI]]     * [[#Trigger GUI]]
Line 48: Line 49:
  
   * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/user/operations/daq/usb/Config**, and click **Load**   * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/user/operations/daq/usb/Config**, and click **Load**
-  +   * Alternatively, it is possible to lead the configuration directly from the module by clicking **Update from Device**
-  * Alternatively, it is possible to lead the configuration directly from the module by clicking **Update from Device** +
   * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a "common" mode to set the same CFD parameters to all channels. Just check **common**   * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a "common" mode to set the same CFD parameters to all channels. Just check **common**
- +  * After modifying any of the CFD parameters, click **Commit to Device**
-  * After modifying any of the CFD parameters, click **Commit to Device**  +
- +
-  * After adjusting the thresholds, the new configuration must be saved in file **MCFD16.tcl** in directory **/user/operations/daq/usb/Config** +
   * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz    * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz 
  
Line 62: Line 57:
  
 ==== Delay Window ==== ==== Delay Window ====
-{{:wiki:482px-Runcontrol.png|Run Control Window}}+{{:wiki:delay-window.png|Delay GUI}}
  
  
s800_daq_tools.txt · Last modified: 2023/10/19 17:25 by swartzj

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki