This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2016/02/29 11:42] pereira [Readout GUI] |
s800_daq_tools [2016/02/29 11:45] pereira [Readout GUI] |
||
---|---|---|---|
Line 27: | Line 27: | ||
**IMPORTANT NOTE:** When running Readout GUI, make sure that the environment variables needed by the system are properly defined. This can be done from a Linux terminal by typing: '' | **IMPORTANT NOTE:** When running Readout GUI, make sure that the environment variables needed by the system are properly defined. This can be done from a Linux terminal by typing: '' | ||
- | Before beginning taking data is necessary to initialize the system. This is done by clicking '' | + | Before beginning taking data is necessary to initialize the system. This is done by clicking '' |
The figure below shows the Readout GUI window after initializing the system. After clicking '' | The figure below shows the Readout GUI window after initializing the system. After clicking '' | ||
Line 36: | Line 36: | ||
- | |||
- | ==== EventBuilder Window ==== | ||
- | |||
- | {{: | ||
- | |||
- | The EventBuilder window will appear as part of starting the [[s800 daq tools#run control window|Run Control]]. This window will communicate statistics such as number of buffers read and number of events broadcast, and will also show error messages, should they occur. | ||