S800 Documentation

User Tools

Site Tools

Trace:
s800_daq_tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
s800_daq_tools [2016/02/29 11:45]
pereira [Readout GUI] 		s800_daq_tools [2016/02/29 11:45]
pereira [Readout GUI]
Line 27: Line 27:
 **IMPORTANT NOTE:** When running Readout GUI, make sure that the environment variables needed by the system are properly defined. This can be done from a Linux terminal by typing: ''. /usr/opt/nscldaq/xxxx/daqsetup.bash'', where ''xxxx'' is the nscldaq version (xxx = 11.0-020, on Feb 2016). **IMPORTANT NOTE:** When running Readout GUI, make sure that the environment variables needed by the system are properly defined. This can be done from a Linux terminal by typing: ''. /usr/opt/nscldaq/xxxx/daqsetup.bash'', where ''xxxx'' is the nscldaq version (xxx = 11.0-020, on Feb 2016).
  
-Before beginning taking data is necessary to initialize the system. This is done by clicking ''Start'' in the ReadoutGUI. After initializing the contollers, the ReadoutGUI window will show the ''Begin'' button active. In addition, three additional buttons should appear at the end of the window. They can be used to start the GUI associated with the [[Mesytec CFD GUI|MCFD]], Delay XLM, and Trigger ULM modules. Make sure that the system is fully initializing before opening those GUIs.+Before beginning taking data is necessary to initialize the system. This is done by clicking ''Start'' in the ReadoutGUI. After initializing the contollers, the ReadoutGUI window will show the ''Begin'' button active. In addition, three additional buttons should appear at the end of the window. They can be used to start the GUI associated with the [[#Mesytec CFD GUI|MCFD]], Delay XLM, and Trigger ULM modules. Make sure that the system is fully initializing before opening those GUIs.
  
 The figure below shows the Readout GUI window after initializing the system. After clicking ''Begin'', the "Event Builder" window will pop out, displaying information about the Readout session. Data can be recorded on disk by checking out the box ''Record''. To end a data run, simply clock ''End''.  The figure below shows the Readout GUI window after initializing the system. After clicking ''Begin'', the "Event Builder" window will pop out, displaying information about the Readout session. Data can be recorded on disk by checking out the box ''Record''. To end a data run, simply clock ''End''. 
s800_daq_tools.txt ยท Last modified: 2023/10/19 17:25 by swartzj

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki