This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2016/02/29 11:45] pereira [Readout GUI] |
s800_daq_tools [2016/02/29 11:49] pereira [Mesytec CFD GUI] |
||
---|---|---|---|
Line 27: | Line 27: | ||
**IMPORTANT NOTE:** When running Readout GUI, make sure that the environment variables needed by the system are properly defined. This can be done from a Linux terminal by typing: '' | **IMPORTANT NOTE:** When running Readout GUI, make sure that the environment variables needed by the system are properly defined. This can be done from a Linux terminal by typing: '' | ||
- | Before beginning taking data is necessary to initialize the system. This is done by clicking '' | + | Before beginning taking data is necessary to initialize the system. This is done by clicking '' |
- | The figure below shows the Readout GUI window after initializing the system. After clicking '' | + | The figure below shows the Readout GUI window after initializing the system. After clicking '' |
Line 44: | Line 44: | ||
- | {{:wiki:mcfd16gui.jpg|MCFD GUI}} | + | {{:wiki:mcfdgui.png|MCFD GUI}} |
* To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | ||
- | * Alternatively, | + | * Alternatively, |
* By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a " | * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a " | ||
* After modifying any of the CFD parameters, click **Commit to Device** | * After modifying any of the CFD parameters, click **Commit to Device** |