Differences

This shows you the differences between two versions of the page.

--- s800_daq_tools [2016/02/29 11:46]
pereira [Readout GUI]
+++ s800_daq_tools [2016/02/29 11:47]
pereira [Readout GUI]
@@ Line 29: / Line 29: @@
 Before beginning taking data is necessary to initialize the system. This is done by clicking ''Start'' in the ReadoutGUI. After initializing the contollers, the ReadoutGUI window will show the ''Begin'' button active. In addition, three additional buttons should appear at the end of the window. They can be used to start the GUI associated with the [[#Mesytec CFD GUI|MCFD]], [[#Delay Window|Delay XLM]], and [[#Trigger GUI|Trigger ULM]] modules. Make sure that the system is fully initializing before opening those GUIs.
-The figure below shows the Readout GUI window after initializing the system. After clicking ''Begin'', the "Event Builder" window will pop out, displaying information about the Readout session. Data can be recorded on disk by checking out the box ''Record''. To end a data run, simply clock ''End''.
+The figure below shows the Readout GUI window after initializing the system. After clicking ''Begin'', the "Event Builder" window will pop out, displaying information about the Readout session. Data can be recorded on disk by checking out the box ''Record''. To end a data run, simply click ''End''.

S800 Documentation