S800 Documentation

User Tools

Site Tools

Trace:
s800_daq_tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
s800_daq_tools [2016/02/29 11:49]
pereira [Mesytec CFD GUI] 		s800_daq_tools [2016/02/29 11:50]
pereira [Readout GUI]
Line 23: Line 23:
  
 ==== Readout GUI ==== ==== Readout GUI ====
-The S800 Readout GUI is invoked by either clicking the icon **S800 DAQ** in the desktop of [[Software#u6pc5 (data U6)|u6pc5]] or by navigating in a Linux terminal to the directory **/user/s800/converged_daq** and typing ''godaq''. The Readout GUI window will appear. +The S800 Readout GUI is invoked by either clicking the icon **S800 DAQ** in the desktop of [[Software#u6pc5 (data U6)|u6pc5]] or by navigating in a Linux terminal to the directory **/user/s800/converged_daq** and typing ''godaq''. The Readout GUI window will appear. **IMPORTANT NOTE:** When running Readout GUI, make sure that the environment variables needed by the system are properly defined. This can be done from a Linux terminal by typing: ''. /usr/opt/nscldaq/xxxx/daqsetup.bash'', where ''xxxx'' is the nscldaq version (xxx = 11.0-020, on Feb 2016).
- +
-**IMPORTANT NOTE:** When running Readout GUI, make sure that the environment variables needed by the system are properly defined. This can be done from a Linux terminal by typing: ''. /usr/opt/nscldaq/xxxx/daqsetup.bash'', where ''xxxx'' is the nscldaq version (xxx = 11.0-020, on Feb 2016).+
  
 Before beginning taking data is necessary to initialize the system. This is done by clicking ''Start'' in the ReadoutGUI. After initializing the contollers, the ReadoutGUI window will show the ''Begin'' button active. In addition, three additional buttons should appear at the end of the window. They can be used to start the GUI associated with the [[#Mesytec CFD GUI|MCFD]], [[#Delay Window|Delay XLM]], and [[#Trigger GUI|Trigger ULM]] modules. Make sure that the system is fully initializing before opening those GUIs. Before beginning taking data is necessary to initialize the system. This is done by clicking ''Start'' in the ReadoutGUI. After initializing the contollers, the ReadoutGUI window will show the ''Begin'' button active. In addition, three additional buttons should appear at the end of the window. They can be used to start the GUI associated with the [[#Mesytec CFD GUI|MCFD]], [[#Delay Window|Delay XLM]], and [[#Trigger GUI|Trigger ULM]] modules. Make sure that the system is fully initializing before opening those GUIs.
s800_daq_tools.txt · Last modified: 2023/10/19 17:25 by swartzj

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki