This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2016/02/29 11:51] pereira [Readout GUI tab] |
s800_daq_tools [2016/02/29 13:12] pereira [Troubleshooting] |
||
---|---|---|---|
Line 2: | Line 2: | ||
* [[#Running the S800 DAQ]] | * [[#Running the S800 DAQ]] | ||
- | * [[#Run Control Window]] | + | * [[#Readout GUI]] |
- | * [[# | + | |
* [[#Mesytec CFD GUI]] | * [[#Mesytec CFD GUI]] | ||
* [[#Delay Window]] | * [[#Delay Window]] | ||
* [[#Trigger GUI]] | * [[#Trigger GUI]] | ||
* [[#Scaler Display]] | * [[#Scaler Display]] | ||
- | | + | |
- | * [[#S800 DAQ status tool]] | + | |
- | * [[#Readout GUI tab]] | + | |
- | * [[# | + | |
- | * [[#Controls tab]] | + | |
* [[#How to run combined S800 + GRETINA]] | * [[#How to run combined S800 + GRETINA]] | ||
Line 92: | Line 87: | ||
- | ==== Troubleshooting ==== | + | ===== Troubleshooting |
+ | There are several common reasons why the S800 DAQ may fails to start. The list below describes what to do to fix these problems. | ||
+ | ==== Manual rebooting | ||
In the rare case that the RunControl GUI gets " | In the rare case that the RunControl GUI gets " | ||
- | ==== Eventbuilder tab ==== | ||
- | The communications port to the eventbuilder is tcp:8100 and it runs by default on spdaq48. These options can be changed in a manner identical to the Readout GUI tab. Information about the current statistics (input/ | ||
- | {{: | + | ===== How to run combined S800 + GRETINA ===== |
+ | OBSOLETE. Documentation is currently under development. | ||
- | This is the only information available to the tcp protocol, but the pid of the processes responsible for these connections can be investigated by using the following commands: | ||
- | |||
- | 1. For each remote host, log in as each user which may be connected to the DAQ (ie e11007, s800). Unfortunately, | ||
- | |||
- | 2. Do **lsof -i | grep port** (where port is replaced by the local port information obtained from the status gui. This will look similar to: | ||
- | |||
- | < | ||
- | netcat.tc 2498 e11007 | ||
- | </ | ||
- | |||
- | where the second column shows the PID of the connecting process. In this case the pid is 2498. | ||
- | |||
- | 3. Do **ps -aux | grep PID**. This will look similar to: | ||
- | |||
- | |||
- | < | ||
- | e11007 | ||
- | </ | ||
- | |||
- | which gives the program name associated with the PID that is connecting to the eventbuilder. | ||
- | |||
- | If the eventbuilder is hanging, which is evidenced by non-increasing statistics and no data/ | ||
- | |||
- | |||
- | |||
- | ===== How to run combined S800 + GRETINA ===== | ||
In order to run the combined S800 + Gretina daq, the following steps need to be taken: | In order to run the combined S800 + Gretina daq, the following steps need to be taken: |