This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2016/02/29 11:53] pereira [S800 Software tools] |
s800_daq_tools [2016/02/29 13:27] pereira [Troubleshooting] |
||
---|---|---|---|
Line 2: | Line 2: | ||
* [[#Running the S800 DAQ]] | * [[#Running the S800 DAQ]] | ||
- | * [[#Run Control Window]] | + | * [[#Readout GUI]] |
- | * [[# | + | |
* [[#Mesytec CFD GUI]] | * [[#Mesytec CFD GUI]] | ||
* [[#Delay Window]] | * [[#Delay Window]] | ||
* [[#Trigger GUI]] | * [[#Trigger GUI]] | ||
* [[#Scaler Display]] | * [[#Scaler Display]] | ||
- | | + | |
* [[#How to run combined S800 + GRETINA]] | * [[#How to run combined S800 + GRETINA]] | ||
Line 88: | Line 87: | ||
- | ==== Troubleshooting ==== | + | ===== Troubleshooting |
+ | There are several common reasons why the S800 DAQ may fails to start. The list below describes what to do to fix these problems. | ||
+ | * [[#No data sources defined]] | ||
+ | ==== No data sources defined ==== | ||
+ | When clicking '' | ||
+ | - Go to **/ | ||
+ | - Copy the file **.settings.tcl** from that directory to the current stagearea. **NOTE**: we are assuming that the stagearea is pointing to the new experiment directory **/ | ||
+ | - If you cannot find that file, there is an old version that can be copied from the directory **/ | ||
+ | - You should now be able to run ReadoutGUI without problem | ||
+ | ==== CCUSB and/or VMUSB claimed by existing programs ==== | ||
+ | One of the most common reasons why the S800 DAQ fails to start is because the CCUSB and/or VMUSB are claimed by existing programs. This is shown by the error messages displayed by the system. If you find yourself in this situation try the following: | ||
+ | - Log on to S800 spdaq (spdaq19 as of October 2015) | ||
+ | - Type '' | ||
+ | - Use '' | ||
+ | - Use '' | ||
+ | - Try '' | ||
+ | - If this didn't help try rebooting the S800 DAQ manually (see below) | ||
+ | ==== Manual rebooting | ||
In the rare case that the RunControl GUI gets " | In the rare case that the RunControl GUI gets " | ||