This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
s800_daq_tools [2016/02/29 13:20] pereira [Troubleshooting] |
s800_daq_tools [2016/02/29 13:26] pereira [No data sources defined] |
||
---|---|---|---|
Line 92: | Line 92: | ||
==== No data sources defined ==== | ==== No data sources defined ==== | ||
- | When clicking '' | + | When clicking '' |
+ | - Go to **/ | ||
+ | - Copy the file **.settings.tcl** from that directory to the current stagearea. **NOTE**: we are assuming that the stagearea is pointing to the new experiment directory **/ | ||
+ | - If you cannot find that file, there is an old version that can be copied from the directory **/ | ||
+ | - You should now be able to run ReadoutGUI without problem | ||
==== CCUSB and/or VMUSB claimed by existing programs ==== | ==== CCUSB and/or VMUSB claimed by existing programs ==== | ||
One of the most common reasons why the S800 DAQ fails to start is because the CCUSB and/or VMUSB are claimed by existing programs. This is shown by the error messages displayed by the system. If you find yourself in this situation try the following: | One of the most common reasons why the S800 DAQ fails to start is because the CCUSB and/or VMUSB are claimed by existing programs. This is shown by the error messages displayed by the system. If you find yourself in this situation try the following: |