This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2016/02/29 13:28] pereira [Troubleshooting] |
s800_daq_tools [2016/02/29 15:00] pereira [Old processes still running] |
||
---|---|---|---|
Line 92: | Line 92: | ||
* [[#CCUSB and/or VMUSB claimed by existing programs]] | * [[#CCUSB and/or VMUSB claimed by existing programs]] | ||
* [[#Manual rebooting]] | * [[#Manual rebooting]] | ||
+ | |||
+ | |||
+ | |||
+ | ==== Old processes still running ==== | ||
+ | Sometimes, particularly if the previous S800 DAQ session ended in an uncontrolled way, there may be old processes running (CCUSB and/or VMUSB and/or S800 event builder) that will prevent Readout GUI to begin a run. Whenever this happens (typically after clicking '' | ||
+ | - Exit your Readout GUI properly | ||
+ | - Type '' | ||
+ | - Type ''/ | ||
+ | - You will see a list of ringbuffers with information about their status (see figure below). Check that the producer value of each ringbuffer (see column '' | ||
+ | - If the producer value of a ringbuffer is not -1, take note of the PID, and kill the process by typing '' | ||
+ | - You should now be able to run Readout GUI and begin a run without problem | ||
+ | |||
+ | |||
+ | {{: | ||
+ | |||
==== No data sources defined ==== | ==== No data sources defined ==== | ||
When clicking '' | When clicking '' |