This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2016/03/04 09:52] pereira [Mesytec CFD GUI] |
s800_daq_tools [2017/04/08 13:21] pereira [Mesytec CFD GUI] |
||
---|---|---|---|
Line 8: | Line 8: | ||
* [[#Scaler Display]] | * [[#Scaler Display]] | ||
* [[# | * [[# | ||
- | * [[#How to run combined S800 + GRETINA]] | + | |
Line 44: | Line 44: | ||
* To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | ||
- | * Alternatively, | + | * Alternatively, |
- | * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a " | + | |
* After modifying any of the CFD parameters, click **Commit to Device** | * After modifying any of the CFD parameters, click **Commit to Device** | ||
+ | * Don't forget to save the new settings in file **MCF16.tcl**. | ||
+ | * Go to '' | ||
* The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | ||
Line 129: | Line 131: | ||
In the rare case that the RunControl GUI gets " | In the rare case that the RunControl GUI gets " | ||
- | |||
- | |||
- | ===== How to run combined S800 + GRETINA ===== | ||
- | OBSOLETE. Documentation is currently under development. | ||
- | |||
- | |||
- | In order to run the combined S800 + Gretina daq, the following steps need to be taken: | ||
- | |||
- | 1. On spdaq48 in / | ||
- | |||
- | **wish ./ | ||
- | |||
- | or, on devop2 (the S800 MAC machine) | ||
- | |||
- | click on the operations folder on the lower icon bar and select runcontrol.command | ||
- | |||
- | 2. On a dataU machine logged in as the experimental account (e11007 for the June 2012 testing period) do | ||
- | |||
- | **godaq** | ||
- | |||
- | 3. On spdaq44 do: | ||
- | |||
- | **/ | ||
- | |||
- | < | ||
- | | ||
- | | ||
- | | ||
- | | ||
- | | ||
- | | ||
- | | ||
- | | ||
- | | ||
- | | ||
- | </ | ||
- | |||
- | Upon start of run there will be another client of the s800 ring, which is the pushToGEB process. This should die on end run. | ||
- | |||
- | |||
- | The S800 daq will now be in slave mode, and run control is done from the NSCL daq window. | ||