This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2016/03/16 15:57] pereira [How to run combined S800 + GRETINA] |
s800_daq_tools [2017/04/08 13:21] pereira [Mesytec CFD GUI] |
||
---|---|---|---|
Line 8: | Line 8: | ||
* [[#Scaler Display]] | * [[#Scaler Display]] | ||
* [[# | * [[# | ||
- | * [[#How to run combined S800 + GRETINA]] | + | |
Line 44: | Line 44: | ||
* To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | ||
- | * Alternatively, | + | * Alternatively, |
- | * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a " | + | |
* After modifying any of the CFD parameters, click **Commit to Device** | * After modifying any of the CFD parameters, click **Commit to Device** | ||
+ | * Don't forget to save the new settings in file **MCF16.tcl**. | ||
+ | * Go to '' | ||
* The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | ||