This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2016/03/16 15:57] pereira [How to run combined S800 + GRETINA] |
s800_daq_tools [2017/04/08 13:26] pereira [Delay Window] |
||
---|---|---|---|
Line 8: | Line 8: | ||
* [[#Scaler Display]] | * [[#Scaler Display]] | ||
* [[# | * [[# | ||
- | * [[#How to run combined S800 + GRETINA]] | + | |
Line 44: | Line 44: | ||
* To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/ | ||
- | * Alternatively, | + | * Alternatively, |
- | * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a " | + | |
* After modifying any of the CFD parameters, click **Commit to Device** | * After modifying any of the CFD parameters, click **Commit to Device** | ||
+ | * Don't forget to save the new settings in file **MCF16.tcl**. | ||
+ | - Go to '' | ||
+ | - Click '' | ||
+ | - Select file **MCFD16tcl** and click '' | ||
+ | - A warning window will pop out to verify that you want to overwrite the existing file. Answer '' | ||
+ | - Click again '' | ||
+ | - Click '' | ||
* The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | ||
Line 58: | Line 65: | ||
- | This window appears when the "Init" button is pressed on the VME crate controller tab as part of the initial setup of the [[s800 daq tools#run control window|S800 USB daq]]. It can also be accessed by pressing the "Show GUIs" button. The delay module allows software configurable delays to be applied to each of the signals indicated in the Channel column, which then form the TDC stops. It is configurable to enable delays to be set with beam on target, as the needed delay may change depending on experimental conditions. | + | This window appears when the "Launch Gate Delay GUI" button is pressed on the [[ReadoutGUI|Readout GUI]]. It can also be accessed by pressing the "Show GUIs" button. The delay module allows software configurable delays to be applied to each of the signals indicated in the Channel column, which then form the TDC stops. It is configurable to enable delays to be set with beam on target, as the needed delay may change depending on experimental conditions. |
Some important things to remember: | Some important things to remember: |