Differences

This shows you the differences between two versions of the page.

--- s800_daq_tools [2016/03/16 15:58]
pereira [S800 Software tools]
+++ s800_daq_tools [2017/04/08 13:18]
pereira [Mesytec CFD GUI]
@@ Line 44: / Line 44: @@
   * To load the default CFD configuration go to **Load Setting**, select file **MCFD16.tcl** in directory **/user/operations/daq/usb/Config**, and click **Load**
-   * Alternatively, it is possible to load the configuration directly from the module by clicking **Update from Device**. However, the names of the channels will not be displayed.
+   * Alternatively, it is possible to load the configuration directly from the module by clicking **Update from Device**.
-  * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a "common" mode to set the same CFD parameters to all channels. Just check **common**
+   * By default, the CFD parameters can be adjusted individually for each of the 16 channels. It is also possible use the module in a "common" mode to set the same CFD parameters to all channels. Just check **common**
   * After modifying any of the CFD parameters, click **Commit to Device**
   * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz

S800 Documentation