s800_daq_tools
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
s800_daq_tools [2017/04/08 13:21] pereira [Mesytec CFD GUI] |
s800_daq_tools [2017/04/08 13:24] pereira [Mesytec CFD GUI] |
||
|---|---|---|---|
| Line 48: | Line 48: | ||
| * After modifying any of the CFD parameters, click **Commit to Device** | * After modifying any of the CFD parameters, click **Commit to Device** | ||
| * Don't forget to save the new settings in file **MCF16.tcl**. | * Don't forget to save the new settings in file **MCF16.tcl**. | ||
| - | * Go to '' | + | |
| + | - Click '' | ||
| + | - Select file **MCFD16tcl** and click '' | ||
| + | - A warning window will pop out to verify that you want to overwrite the existing file. Answer '' | ||
| + | - Click again '' | ||
| + | - Click '' | ||
| * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | ||
s800_daq_tools.txt · Last modified: 2023/10/19 17:25 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
