s800_daq_tools
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
s800_daq_tools [2017/04/08 13:21] pereira [Mesytec CFD GUI] |
s800_daq_tools [2017/04/08 13:26] pereira [Delay Window] |
||
|---|---|---|---|
| Line 48: | Line 48: | ||
| * After modifying any of the CFD parameters, click **Commit to Device** | * After modifying any of the CFD parameters, click **Commit to Device** | ||
| * Don't forget to save the new settings in file **MCF16.tcl**. | * Don't forget to save the new settings in file **MCF16.tcl**. | ||
| - | * Go to '' | + | |
| + | - Click '' | ||
| + | - Select file **MCFD16tcl** and click '' | ||
| + | - A warning window will pop out to verify that you want to overwrite the existing file. Answer '' | ||
| + | - Click again '' | ||
| + | - Click '' | ||
| * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | * The MCFD module includes the possibility to send a periodic pulsing signal to all the channels. Two frequencies can be selected: 1.22 KHz, and 2.5 MHz | ||
| Line 60: | Line 65: | ||
| - | This window appears when the "Init" button is pressed on the VME crate controller tab as part of the initial setup of the [[s800 daq tools#run control window|S800 USB daq]]. It can also be accessed by pressing the "Show GUIs" button. The delay module allows software configurable delays to be applied to each of the signals indicated in the Channel column, which then form the TDC stops. It is configurable to enable delays to be set with beam on target, as the needed delay may change depending on experimental conditions. | + | This window appears when the "Launch Gate Delay GUI" button is pressed on the [[ReadoutGUI|Readout GUI]]. It can also be accessed by pressing the "Show GUIs" button. The delay module allows software configurable delays to be applied to each of the signals indicated in the Channel column, which then form the TDC stops. It is configurable to enable delays to be set with beam on target, as the needed delay may change depending on experimental conditions. |
| Some important things to remember: | Some important things to remember: | ||
s800_daq_tools.txt · Last modified: 2023/10/19 17:25 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
