S800 Documentation

User Tools

Site Tools

Trace:
s800_daq_tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
s800_daq_tools [2017/04/08 13:30]
pereira [Delay Window] 		s800_daq_tools [2017/06/16 18:23]
pereira old revision restored (2017/06/16 18:18)
Line 7: Line 7:
     * [[#Trigger GUI]]     * [[#Trigger GUI]]
     * [[#Scaler Display]]     * [[#Scaler Display]]
 +    * [[#Running in Slave mode with multilogger]]
   * [[#Troubleshooting]]   * [[#Troubleshooting]]
  
Line 83: Line 84:
 {{:wiki:800px-TriggerGUI.png?800|right|Trigger GUI}} {{:wiki:800px-TriggerGUI.png?800|right|Trigger GUI}}
  
-The Trigger GUI appears when the "Init" button is pressed on the CAMAC crate controller tab as part of the initial setup of the [[s800 daq tools#run control window|S800 USB daq]]. The Trigger GUI is a visual display of the various Gate and Delay Generators and logic elements that make up the configurable trigger of the S800. The logic of the trigger decision is readily discerned from a visual inspection of this GUI. Setting the trigger configuration is also done using this GUI by right clicking on any of the wires to put that signal onto one of the four "Trigger Inspect" channels available at the patch panel of Data-U6. By inspecting the various delays, widths and overlaps the user trigger can be configured. The Trigger GUI is discussed in greater detail [[Trigger|here]].+The Trigger GUI appears when the "Launch ULM GUI" button is pressed on [[#Readout GUI]]. The Trigger GUI is a visual display of the various Gate and Delay Generators and logic elements that make up the configurable trigger of the S800. The logic of the trigger decision is readily discerned from a visual inspection of this GUI. Setting the trigger configuration is also done using this GUI  
 + 
 +The different signal going through the trigger scheme can be inspected in th Data-U6 oscilloscope. Simply right click on any of the wires to put that signal onto one of the four "Trigger Inspect" channels available at the patch panel of Data-U6, and connect that patch-panel cable to the oscilloscope. By inspecting the various delays, widths and overlaps the user trigger can be configured. The Trigger GUI is discussed in greater detail [[Trigger|here]].
  
  
s800_daq_tools.txt · Last modified: 2023/10/19 17:25 by swartzj

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki