This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2017/06/16 18:24] pereira [Scaler Display] |
s800_daq_tools [2017/06/16 18:48] pereira [Running in Slave mode with multilogger] |
||
---|---|---|---|
Line 101: | Line 101: | ||
==== Running in Slave mode with multilogger ==== | ==== Running in Slave mode with multilogger ==== | ||
+ | The S800 DAQ can be run in Standalone mode (as described above), or in Slave mode. The later means that the S800 DAQ is controlled by an external DAQ (e.g. GRETINA). In this mode, the S800 ULM receives an external clock signal and external synchronization from the master DAQ. Running in Slave mode requires to change the script **CC0105Begin.tcl** in directory **/ | ||
+ | |||
+ | |||
+ | One of the | ||
+ | |||
+ | |||
+ | |||
+ | {{: | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
+ | |||
===== Troubleshooting ===== | ===== Troubleshooting ===== | ||
There are several common reasons why the S800 DAQ may fails to start. The list below describes what to do to fix these problems. | There are several common reasons why the S800 DAQ may fails to start. The list below describes what to do to fix these problems. |