This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2017/06/16 18:48] pereira [Running in Slave mode with multilogger] |
s800_daq_tools [2017/06/16 19:06] pereira [Running in Slave mode with multilogger] |
||
---|---|---|---|
Line 101: | Line 101: | ||
==== Running in Slave mode with multilogger ==== | ==== Running in Slave mode with multilogger ==== | ||
- | The S800 DAQ can be run in Standalone mode (as described above), or in Slave mode. The later means that the S800 DAQ is controlled by an external DAQ (e.g. GRETINA). In this mode, the S800 ULM receives | + | The S800 DAQ can be run in Standalone mode (as described above), or in Slave mode. The later means that the S800 DAQ is controlled by an external DAQ (e.g. GRETINA). In this mode, the S800 ULM receives external clock and external synchronization |
- | One of the | + | By default, when running in Slave mode, data are recorded in the stagearea |
+ | Before running an experiment with a Master system (e.g. GRETINA), it is recommendable to run the S800 DAQ in Slave mode with the s800filter multilogger enabled. This can be done following the steps: | ||
+ | * Click to the tab '' | ||
- | {{: | + | * Select the option " |
+ | * Click again on the tab '' | ||
+ | * Check out s800filter to enable recording data from this ring buffer | ||
+ | |||
+ | * After this, S800 data from every run recorded by the experimenters, | ||