This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2017/06/16 19:03] pereira [Running in Slave mode with multilogger] |
s800_daq_tools [2017/06/17 14:27] pereira [Running in Slave mode with multilogger] |
||
---|---|---|---|
Line 106: | Line 106: | ||
By default, when running in Slave mode, data are recorded in the stagearea of the Master DAQ (experiment account). It is however possible to record simultaneously data from the S800 into the S800 stagearea, using the '' | By default, when running in Slave mode, data are recorded in the stagearea of the Master DAQ (experiment account). It is however possible to record simultaneously data from the S800 into the S800 stagearea, using the '' | ||
- | Before | + | When running |
* Click to the tab '' | * Click to the tab '' | ||
Line 112: | Line 112: | ||
* Select the option " | * Select the option " | ||
- | * Click again on the tab '' | + | * Click again on the tab '' |
- | * Check out the ring-buffer '' | + | * Check out s800filter to enable recording data from this ring buffer |
* After this, S800 data from every run recorded by the experimenters, | * After this, S800 data from every run recorded by the experimenters, | ||
- | + | * After finishing XDT, it is better to disable the s800filter ring-buffer in the multilogger menu so the S800 stagearea doesn' | |