This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2017/06/16 19:04] pereira [Running in Slave mode with multilogger] |
s800_daq_tools [2017/07/17 17:39] pereira [Troubleshooting] |
||
---|---|---|---|
Line 106: | Line 106: | ||
By default, when running in Slave mode, data are recorded in the stagearea of the Master DAQ (experiment account). It is however possible to record simultaneously data from the S800 into the S800 stagearea, using the '' | By default, when running in Slave mode, data are recorded in the stagearea of the Master DAQ (experiment account). It is however possible to record simultaneously data from the S800 into the S800 stagearea, using the '' | ||
- | Before | + | When running |
* Click to the tab '' | * Click to the tab '' | ||
Line 114: | Line 114: | ||
* Click again on the tab '' | * Click again on the tab '' | ||
- | * Check out the ring-buffer '' | + | * Check out s800filter to enable recording data from this ring buffer |
+ | |||
+ | | ||
+ | |||
+ | | ||
Line 120: | Line 124: | ||
===== Troubleshooting ===== | ===== Troubleshooting ===== | ||
- | There are several common reasons why the S800 DAQ may fails to start. The list below describes what to do to fix these problems. | + | There are several common reasons why the S800 DAQ may fail. The list below describes what to do to fix some of these problems. |
- | * [[#Old processes still running]] | + | * [[#Old processes still running|Error message: " |
* [[#No data sources defined]] | * [[#No data sources defined]] | ||
* [[#CCUSB and/or VMUSB claimed by existing programs]] | * [[#CCUSB and/or VMUSB claimed by existing programs]] |