This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_daq_tools [2023/04/20 15:43] swartzj |
s800_daq_tools [2023/09/22 12:59] swartzj |
||
---|---|---|---|
Line 24: | Line 24: | ||
- | After initializing the contollers, the ReadoutGUI window will show the '' | + | After initializing the controllers, the ReadoutGUI window will show the '' |
Before beginning a run, you have to make sure that the ULM trigger module is properly configured. This can be done by clicking the button [[#Trigger GUI|Launch ULM GUI]] in the ReadoutGUI window. | Before beginning a run, you have to make sure that the ULM trigger module is properly configured. This can be done by clicking the button [[#Trigger GUI|Launch ULM GUI]] in the ReadoutGUI window. | ||
Line 168: | Line 168: | ||
==== For hodoscope runs, cannot read signal from hodoscope ==== | ==== For hodoscope runs, cannot read signal from hodoscope ==== | ||
If you see this kind error message when starting the DAQ with the hodoscope in the trigger (Ext. 1 in ULM gui), check the voltages on the crate which holds the hodoscope shaper modules. If they are not at the correct values, follow this procedure: | If you see this kind error message when starting the DAQ with the hodoscope in the trigger (Ext. 1 in ULM gui), check the voltages on the crate which holds the hodoscope shaper modules. If they are not at the correct values, follow this procedure: | ||
- | - Ordered List ItemTurn | + | - Turn crate off |
- Unplug both shapers (for both hodoscopes). Just pull them but don’t fully remove the cards. | - Unplug both shapers (for both hodoscopes). Just pull them but don’t fully remove the cards. | ||
- With shapers unplugged, turn crate on and check voltages | - With shapers unplugged, turn crate on and check voltages |