User Tools

Site Tools


s800_daq_tools

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
s800_daq_tools [2023/08/07 16:16]
swartzj
s800_daq_tools [2023/09/22 12:59]
swartzj
Line 24: Line 24:
  
  
-After initializing the contollers, the ReadoutGUI window will show the ''Begin'' button active. In addition, three additional buttons should appear at the end of the window. They can be used to start the GUI associated with the [[#Mesytec CFD GUI|MCFD]], [[#Delay Window|Delay XLM]], and [[#Trigger GUI|Trigger ULM]] modules. Make sure that the system is completely initializing before opening those GUIs.+After initializing the controllers, the ReadoutGUI window will show the ''Begin'' button active. In addition, three additional buttons should appear at the end of the window. They can be used to start the GUI associated with the [[#Mesytec CFD GUI|MCFD]], [[#Delay Window|Delay XLM]], and [[#Trigger GUI|Trigger ULM]] modules. Make sure that the system is completely initializing before opening those GUIs.
  
 Before beginning a run, you have to make sure that the ULM trigger module is properly configured. This can be done by clicking the button [[#Trigger GUI|Launch ULM GUI]] in the ReadoutGUI window. Before beginning a run, you have to make sure that the ULM trigger module is properly configured. This can be done by clicking the button [[#Trigger GUI|Launch ULM GUI]] in the ReadoutGUI window.
s800_daq_tools.txt ยท Last modified: 2023/10/19 17:25 by swartzj