This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_spectcl [2013/12/12 13:04] pereira [Frequently used parameters for the S800] |
s800_spectcl [2013/12/17 13:17] pereira [S800 SpecTcl] |
||
---|---|---|---|
Line 3: | Line 3: | ||
- | The SpecTcl Control has been adapted for special functions required for the analysis of S800 data. Fig xxx shows the GUI control of the S800 analysis. | + | The SpecTcl Control has been adapted for special functions required for the analysis of S800 data. The figure below shows the GUI control of the S800 analysis. |
{{: | {{: | ||
Line 62: | Line 62: | ||
+ | ===== Sample spectra ===== | ||
+ | The following figures depict some of the S800 SpecTcl spectra used for the tunning of the S800. | ||
+ | ==== Energy loss in the ion chamber vs. time of flight measured between the object scintillator and the E1 scintillator (trigger) at the end of the focal plane ==== | ||
+ | {{: | ||
+ | // | ||
+ | // | ||
+ | // | ||
+ | // | ||
+ | // | ||
+ | // | ||
+ | ====(In)elastic scattering of the incoming " | ||
+ | {{: | ||
+ | |||
+ | |||
+ | |||
+ | |||
+ | ==== Sn-124 primary beam passing a thick Al viewer at the target position (focused optics) ==== | ||
+ | |||
+ | {{: | ||
+ | |||
+ | **Upper left**: Three < | ||
+ | |||
+ | **Upper right**: Amplitude of the CRDC2 anode signal vs. drift time (this is a diagnostics spectrum showing that the response of the CRDC is not correlated with the y position). | ||
+ | |||
+ | **Lower left**: Raw drift time measured in CRDC2 | ||
+ | |||
+ | **Lower right**: Charge distribution induced in the pads by the three < | ||