This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_spectcl [2018/03/09 14:19] pereira |
s800_spectcl [2018/03/09 14:32] pereira [S800 SpecTcl installation in S800 computer] |
||
---|---|---|---|
Line 104: | Line 104: | ||
===== S800 SpecTcl installation in S800 computer ===== | ===== S800 SpecTcl installation in S800 computer ===== | ||
+ | Before installing the S800 SpecTcl make sure to contact the S800 Device Physicist (Jorge Pereira). The process | ||
+ | |||
+ | In order to install S800 SpecTcl in the S800 computer, follow the following steps: | ||
+ | |||
+ | - Check that the environment variable SPECTCLBINDIR is well defined: echo $SPECTCLBINDIR should give you **/ | ||
+ | - Go to **/ | ||
+ | - Clone the master branch from the remote repository '' | ||
+ | - Type '' | ||
+ | - Goes to subdirectory **/ | ||
+ | - Goes to subdirectory **/src**, runs make clean, and make (this creates the SpecTcl binary) and moves it to the Main directory (up) | ||
+ | - Creates SpecTcl-running directory defined in **SPECTCLBINDIR=/ | ||
+ | - Moves " | ||
+ | - This gets the software necessary to run SpecTcl ready in directory **/ | ||
+ | - SpecTcl can now be run by typing '' | ||
+ | |||
............................. | ............................. | ||