This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
s800_spectcl [2018/03/09 14:27] pereira [S800 SpecTcl installation in S800 computer] |
s800_spectcl [2018/03/09 14:34] pereira old revision restored (2018/03/09 14:29) |
||
---|---|---|---|
Line 108: | Line 108: | ||
In order to install S800 SpecTcl in the S800 computer, follow the following steps: | In order to install S800 SpecTcl in the S800 computer, follow the following steps: | ||
- | 1. Check that the environment variable SPECTCLBINDIR is well defined: echo $SPECTCLBINDIR should give you / | + | - Check that the environment variable SPECTCLBINDIR is well defined: echo $SPECTCLBINDIR should give you / |
- | 2. Go to ~/ | + | |
- | 3. Clone the master branch from the remote repository: git clone git@git.nscl.msu.edu: | + | |
- | 4. Type Make -f Make.s800 Install. This Makefile does the following: | + | |
- | 1. Goes to subdirectory /libnumrec, runs make clean, and make LIBLITE (to clear objects and create library libnumreclite.a and moves the library to the ../src subdirectory | + | |
- | 2. Goes to subdirectory /src, runs make clean, and make (this creates the SpecTcl binary) and moves it to the Main directory (up) | + | |
- | 3. Creates SpecTcl-running directory defined in SPECTCLBINDIR=/ | + | |
- | 4. Moves " | + | |
- | + | ||
- | 5. This gets the software necessary to run SpecTcl ready in directory / | + | |
- | 6. I added a script gospectcl to the binary directory / | + | |
+ | - This gets the software necessary to run SpecTcl ready in directory / | ||
+ | - I added a script gospectcl to the binary directory / | ||
............................. | ............................. | ||