Differences

This shows you the differences between two versions of the page.

--- s800_spectcl [2018/03/10 14:07]
pereira [S800 SpecTcl installation in S800 computer]
+++ s800_spectcl [2018/03/10 14:07]
pereira [S800 SpecTcl installation in S800 computer]
@@ Line 112: / Line 112: @@
   - Check that the environment variable SPECTCLBINDIR is well defined: '' echo $SPECTCLBINDIR '' should give you **/user/s800/s800spectcl**. If that's not the case, edit .bashrc and define the variable (make sure to source .bashrc afterwards).
   - Go to **/user/s800/s800develop/s800spectcl_develop** and clean its content
-  - Clone the master branch from the remote repository: ''git clone git@git.nscl.msu.edu:pereira/s800spectcl.git master'' (NOTE: the deployment of this repository is password protected. Contact Jorge Pereira (pereira@nscl.msu.edu), Ron Fox (fox@nscl.msu.edu), or Giordano Cerizza (cerizza@nscl.msu.edu) for assistance.
+  - Clone the master branch from the remote repository: ''git clone git@git.nscl.msu.edu:pereira/s800spectcl.git master'' (NOTE: the deployment of this repository is password protected. Contact Jorge Pereira (pereira@nscl.msu.edu), Ron Fox (fox@nscl.msu.edu), or Giordano Cerizza (cerizza@nscl.msu.edu) for assistance).
-)
   - Type ''Make -f Make.s800 Install''. This Makefile does the following:
             - Goes to subdirectory **/libnumrec**, runs make clean, and make LIBLITE (to clear objects and create library libnumreclite.a and moves the library to the **../src** subdirectory

S800 Documentation