Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
Next revision
|
Previous revision
Next revision
Both sides next revision
|
to-do_list [2015/10/20 13:48] pereira [In data U6] |
to-do_list [2017/04/06 10:48] pereira [In data U6] |
* Start [[Software#u6pc5 (data U6)|Software applications]] (in computer u6pc5) | * Start [[Software#u6pc5 (data U6)|Software applications]] (in computer u6pc5) |
| |
* Verify that **stagearea** in u6pc5 is pointing to the right place. After typing "ls -l ~/stagearea" in a u6pc5 terminal, you should see: **/user/s800/stagearea -> /mnt/daqtesting/s800/exxxxx**, where xxxxx corresponds to the experiment number. If the experiment number is not right, follow the following steps: | * Source the environment file to run the DAQ: |
* Create a experiment directory in **/mnt/daqtesting/s800** by typing "mkdir exxxxx" | * Open a terminal in u6pc5 and type ''ssh -Y spdaq19'' |
* Go to the newly created experiment directory, and create subdirectories **s800built**, **rawccusb**, and **rawvmusb** | * Type ''. /usr/opt/nscldaq/xxxx/daqsetup.bash'', where xxxx is the nscldaq version number (11.0-015 on Oct 26, 2015) |
* Create the stagearea link by typing "ln -s /mnt/daqtesting/s800/exxxxx stagearea" | |
* Run the S800 DAQ with multilogger enabled, and take some data on disk to ensure that the newly created stagearea is properly filled | * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing ''ls -l ~/stagearea'' in a u6pc5 terminal, you should see: **/user/s800/stagearea -> /mnt/daqtesting/s800/exxxxx**, where xxxxx corresponds to the experiment number. If the experiment number is not right, run script **goinstall** from any directory, and follow the intructions. After that, verify that the stagearea is correct. |
| |
| * Check [[s800 daq tools#scaler display|scalers]] while running S800 DAQ |
| |
| |