S800 Documentation

User Tools

Site Tools

Trace:
to-do_list

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
to-do_list [2016/02/29 13:03]
pereira [In data U6] 		to-do_list [2017/06/16 19:08]
pereira [In data U6]
Line 26: Line 26:
         * Type ''. /usr/opt/nscldaq/xxxx/daqsetup.bash'', where xxxx is the nscldaq version number (11.0-015 on Oct 26, 2015)         * Type ''. /usr/opt/nscldaq/xxxx/daqsetup.bash'', where xxxx is the nscldaq version number (11.0-015 on Oct 26, 2015)
  
-  * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing ''ls -l ~/stagearea'' in a u6pc5 terminal, you should see: **/user/s800/stagearea -> /mnt/daqtesting/s800/exxxxx**, where xxxxx corresponds to the experiment number. If the experiment number is not right, follow the following steps: +  * Verify that **stagearea** in u6pc5 is pointing to the right place. After typing ''ls -l ~/stagearea'' in a u6pc5 terminal, you should see: **/user/s800/stagearea -> /mnt/daqtesting/s800/exxxxx**, where xxxxx corresponds to the experiment number. If the experiment number is not right, run script **goinstall** from any directory, and follow the intructions. After that, verify that the stagearea is correct.
-        * Create a experiment directory in **/mnt/daqtesting/s800** by typing ''mkdir exxxxx'' +
-        * Go to the newly created experiment directory, and create subdirectories **s800built**, **rawccusb**, and **rawvmusb** +
-        * Remove the old stagearea link ''rm ~/stagearea'' +
-        * Create a new stagearea link by typing ''ln -s /mnt/daqtesting/s800/exxxxx ~/stagearea''  +
-        * Move the hidden setting file **.settings.tcl** from the previous experiment directory where stagearea was pointing to (under directory **/mnt/daqtesting/s800/** ) to the current one. If you cannot find that file, there is an old version that can be copied from the directory **/user/s800/converged_daq**  +
-        * Run the S800 DAQ with multilogger enabled, and take some data on disk to ensure that the newly created stagearea is properly filled +
-  * Check [[s800 daq tools#scaler display|scalers]] while running S800 DAQ+
  
 +  * Set S800 DAQ in [[s800 daq tools#Running in Slave mode with multilogger |Slave mode and enable multilogger]] to record S800 data in the s800 stagearea.
 + 
 +  * Check [[s800 daq tools#scaler display|scalers]] while running S800 DAQ
  
   * [[Turning magnets on/off#Set magnet currents individually |Put 10 Amps in Spectrograph dipoles]]   * [[Turning magnets on/off#Set magnet currents individually |Put 10 Amps in Spectrograph dipoles]]
to-do_list.txt · Last modified: 2023/10/19 17:15 by swartzj

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki