S800 Documentation

User Tools

Site Tools

Trace:
trigger

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
trigger [2013/12/11 14:40]
pereira [Time Stamping Scheme] 		trigger [2013/12/11 14:42]
pereira
Line 9: Line 9:
   - Direct visualization of the trigger logic and configuration    - Direct visualization of the trigger logic and configuration 
  
-Probably the most appealing feature of this module is the possibility to remotely control the trigger timing and configuration while beam is present in the vault, since most experiments are nowadays locating their electronics close to the detectors. For more details on this detector check section [[Trigger#Trigger module|Trigger module]].+Probably the most appealing feature of this module is the possibility to remotely control the trigger timing and configuration while beam is present in the vault, since most experiments are nowadays locating their electronics close to the detectors. For more details on this detector check section "[[Trigger#Trigger module|Trigger module]]".
  
  
Line 45: Line 45:
  
 ==== Time Stamping Scheme ==== ==== Time Stamping Scheme ====
-Because the USB-based S800 data acquisition uses independent crate controllers that perform the readout in parallel, time stamping schemes are incorporated in the trigger to synchronize events. Because of this modularity, adding an external data acquisition system (typically from an external detector), is straightforward. More details about the time stamping module can be found in section [Trigger#Time stamping|Time stamping]].+Because the USB-based S800 data acquisition uses independent crate controllers that perform the readout in parallel, time stamping schemes are incorporated in the trigger to synchronize events. Because of this modularity, adding an external data acquisition system (typically from an external detector), is straightforward. More details about the time stamping module can be found in section [[Trigger#Time stamping|Time stamping]].
  
  
Line 121: Line 121:
  
  
-====== Time Stamping ======+====== Time stamping ======
 The S800 trigger provides a vetoed 10 MHz clock signal (derived from the 40 MHz FPGA clock) used for time stamping. An external clock can also be used, after selecting the appropriate check box in the [[Trigger#Trigger Schematic|GUI]]). The clock is inhibited by a "Go" signal controlled by the trigger module. While "Go" is false, all time stamp counters can be reset via CAMAC command, typically during the begin sequences of the controllers or data acquisitions (see section on [[begin sequence]]). The clock signal is released when the "Go" signal is set to true at the end of the begin sequence. This simple scheme insures that all time stamp counters are synchronized.  The S800 trigger provides a vetoed 10 MHz clock signal (derived from the 40 MHz FPGA clock) used for time stamping. An external clock can also be used, after selecting the appropriate check box in the [[Trigger#Trigger Schematic|GUI]]). The clock is inhibited by a "Go" signal controlled by the trigger module. While "Go" is false, all time stamp counters can be reset via CAMAC command, typically during the begin sequences of the controllers or data acquisitions (see section on [[begin sequence]]). The clock signal is released when the "Go" signal is set to true at the end of the begin sequence. This simple scheme insures that all time stamp counters are synchronized. 
  
trigger.txt ยท Last modified: 2023/10/24 16:47 by swartzj

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki