S800 Documentation

User Tools

Site Tools

Trace:
trigger

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
trigger [2014/03/11 11:20]
pereira [Scalers and dead time] 		trigger [2014/12/01 15:26]
pereira [Trigger schematics]
Line 36: Line 36:
 ===== Trigger schematics ===== ===== Trigger schematics =====
    
-The trigger schematic is shown on the Graphical User Interface (GUI) displayed in the figure below. +The trigger schematic is shown on the Graphical User Interface (GUI) displayed in the figure below. The GUI is automatically displayed when clicking in the Readout icon of the [[software|u6pc5]] desktop.
  
 {{:wiki:TriggerGUI.png?900|Trigger schematics of the S800}} {{:wiki:TriggerGUI.png?900|Trigger schematics of the S800}}
Line 181: Line 181:
 | Hodo.OR       ^ 30 |                ^  |  | Hodo.OR       ^ 30 |                ^  | 
  
-In principle, it is possible to include other signals into the scaler channels that are not used. This requires some manipulation of tcl scripts, according to the following steps: +In principle, it is possible to include other signals into the scaler channels that are not used. This requires changes in some of the tcl scripts. Make sure that you communicate with the S800 responsible, and of course, do not do anything if you don't know what you are doing. The list below describes the steps that need to be followed to include new channels in the scaler.
  
   * Modify the scaler display script to include the new signals: Go to **/user/s800/Documents/Run/scalers/USBDAQ** and edit file **s800scl.des** to include the new channels (make sure that you make a copy of the old file so that it can be recovered when the new signals are not needed anymore). Save the new file.   * Modify the scaler display script to include the new signals: Go to **/user/s800/Documents/Run/scalers/USBDAQ** and edit file **s800scl.des** to include the new channels (make sure that you make a copy of the old file so that it can be recovered when the new signals are not needed anymore). Save the new file.
trigger.txt · Last modified: 2023/10/24 16:47 by swartzj

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
CC Attribution-Noncommercial-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki