tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/21 14:03] pereira |
tuning_the_s800_xdt [2015/10/21 14:13] pereira |
||
|---|---|---|---|
| Line 123: | Line 123: | ||
| * Count rate is a little higher than on scintillator due to noise or thresholds | * Count rate is a little higher than on scintillator due to noise or thresholds | ||
| - | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** to verify the good performance of the detectors. (The spectra for each CRDC can be checked separatelly in windows **s800_CRDC1.win** and **S800_CRDC2.win**) | + | * Check **[[s800 SpecTcl|Spectcl]]** window **S800_CRDCS.win** |
| * Spectra **crdc1.raws** and **crdc2.raws** (top and middle spectra in the leftmost (first) column) | * Spectra **crdc1.raws** and **crdc2.raws** (top and middle spectra in the leftmost (first) column) | ||
| Line 130: | Line 130: | ||
| * Width of beam peak is proportional to A1900 p-acceptance in focus optics | * Width of beam peak is proportional to A1900 p-acceptance in focus optics | ||
| * Width is narrower in match optics | * Width is narrower in match optics | ||
| - | * Adjust anode HV to bring fuzzy maximum to around 600-700 channels (the ADC for each pad saturates | + | * Adjust anode HV to bring fuzzy maximum to around 600-700 channels (saturation of each pad at ~ 1000 ch) |
| * Spectra **crdc1.anode_crdc1.tac** and **crdc2.anode_crdc2.tac** (top and middle spectra in the second column) | * Spectra **crdc1.anode_crdc1.tac** and **crdc2.anode_crdc2.tac** (top and middle spectra in the second column) | ||
| Line 146: | Line 146: | ||
| | | ||
| * Spectra **crdc1.xg** and **crdc2.xg** (bottom spectra in first and second columns) | * Spectra **crdc1.xg** and **crdc2.xg** (bottom spectra in first and second columns) | ||
| - | * It shows the position of the beam in the dispersive direction, evaluated by calculating the " | + | * It shows the position of the beam in the dispersive direction, evaluated by calculating the " |
| - | * Spectra **crdc1.tac** and **crdc2.tac** (bottom spectra in third and fourth columns) | ||
| - | * They correspond to the non-dispersive position of the beam in the CRDCs. The peak should be in the middle of the spectra in order to center the beam | ||
| + | * Spectra **crdc1.tac** and **crdc2.tac** (bottom spectra in third and fourth columns) | ||
| + | * They correspond to the non-dispersive position of the beam in the CRDCs. | ||
| {{: | {{: | ||
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
