tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/22 16:48] pereira |
tuning_the_s800_xdt [2015/10/22 16:52] pereira |
||
|---|---|---|---|
| Line 168: | Line 168: | ||
| * The OBJ signal into the MCFD comes directly from the detector via S3 patch panel #94 (i.e., there is no signal to check in data U6) | * The OBJ signal into the MCFD comes directly from the detector via S3 patch panel #94 (i.e., there is no signal to check in data U6) | ||
| * The XFP signal into the MCFD module comes from data-U6 patch panel #70, connected to the CANBERRA 454 CFD XFP output | * The XFP signal into the MCFD module comes from data-U6 patch panel #70, connected to the CANBERRA 454 CFD XFP output | ||
| - | * SpecTcl calculates the ToF by substracting the MTDC time from XFP (MTDC channel | + | * SpecTcl calculates the OBJ-to-Focal-Plane and XFP-to-Focal-Plane ToFs by substracting the E1 up time (MTDC channel |
| * The MTDC timing signals do not require external delay adjustments because the matching window is sufficiently wide | * The MTDC timing signals do not require external delay adjustments because the matching window is sufficiently wide | ||
| * Tennelec TACs: | * Tennelec TACs: | ||
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
