This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
tuning_the_s800_xdt [2015/10/22 16:48] pereira |
tuning_the_s800_xdt [2015/10/22 16:57] pereira |
||
---|---|---|---|
Line 163: | Line 163: | ||
* There are three electronic " | * There are three electronic " | ||
* Although the ToF reference (" | * Although the ToF reference (" | ||
- | * Before going to the ToF modules, the OBJ and XFP signals are sent to a CANBERRA CFD 454 CFD in data U6 from the data-U6 patch panel (OBJ: patch panel #54, XFP: patch panel #1) | + | * Before going to the ToF modules, the OBJ and XFP signals are sent to a CANBERRA CFD 454 CFD in data U6 from the data-U6 patch panel (OBJ: patch panel #54, XFP: patch panel #1). (The exception is the OBJ signal into the MTDC) |
* MTDC: | * MTDC: | ||
* Before getting into the MTDC, the OBJ, XFP, and E1 up signals in the MTDC go through a Mesytec MCFD | * Before getting into the MTDC, the OBJ, XFP, and E1 up signals in the MTDC go through a Mesytec MCFD | ||
* The OBJ signal into the MCFD comes directly from the detector via S3 patch panel #94 (i.e., there is no signal to check in data U6) | * The OBJ signal into the MCFD comes directly from the detector via S3 patch panel #94 (i.e., there is no signal to check in data U6) | ||
* The XFP signal into the MCFD module comes from data-U6 patch panel #70, connected to the CANBERRA 454 CFD XFP output | * The XFP signal into the MCFD module comes from data-U6 patch panel #70, connected to the CANBERRA 454 CFD XFP output | ||
- | * SpecTcl calculates the ToF by substracting the MTDC time from XFP (MTDC channel | + | * SpecTcl calculates the OBJ-to-Focal-Plane and XFP-to-Focal-Plane ToFs by substracting the E1 up time (MTDC channel |
* The MTDC timing signals do not require external delay adjustments because the matching window is sufficiently wide | * The MTDC timing signals do not require external delay adjustments because the matching window is sufficiently wide | ||
* Tennelec TACs: | * Tennelec TACs: |