tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/26 13:21] pereira [Timing setup] |
tuning_the_s800_xdt [2015/10/26 13:25] pereira [Timing setup] |
||
|---|---|---|---|
| Line 175: | Line 175: | ||
| * If necessary, adjust delays: | * If necessary, adjust delays: | ||
| - | * Using ULM GUI assign TDC-start to one of the Inspect Trigger channels and trigger the scope with it | + | * Using the [[S800 DAQ tools# |
| - | * Select the timing signals (Delay inspect channels) E1 up, OBJ and XFP with the Delay GUI and look at them in the scope | + | * Select the timing signals (Delay inspect channels) E1 up, OBJ and XFP with the [[S800 DAQ tools#Delay Window|Delay GUI]] and look at them in the scope |
| - | * Adjust the TDC delays of OBJ and XFP using the delay boxes connected to the CANBERRA CFD in data U6 | + | * Adjust the TDC delays of OBJ and XFP using the delay boxes connected to the CANBERRA CFD 454 in data U6 |
| * Adjust the TDC delays of E1 up, down using the Delay GUI | * Adjust the TDC delays of E1 up, down using the Delay GUI | ||
| * In principle, the TACs delays don't need to be adjusted | * In principle, the TACs delays don't need to be adjusted | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
