tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/26 13:56] pereira [Checking Particle ID and rate at S800 FP] |
tuning_the_s800_xdt [2015/10/26 13:58] pereira [Checking Particle ID and rate at S800 FP] |
||
|---|---|---|---|
| Line 199: | Line 199: | ||
| * Take a run on disk | * Take a run on disk | ||
| * Measure the beam intensity again and calculate the average value | * Measure the beam intensity again and calculate the average value | ||
| - | * In SpecTcl GUI, click **Attach to File** and select data file **run-xxxx-xx.evt** in directory **/ | + | * In **[[s800 SpecTcl|SpecTcl GUI]], click **Attach to File** and select data file **run-xxxx-xx.evt** in directory **/ |
| * Check the run time and live time from the corresponding scaler file in directory **/ | * Check the run time and live time from the corresponding scaler file in directory **/ | ||
| * Calculate the rate and purity and compare with the value in the A1900 FP to determine the transmission | * Calculate the rate and purity and compare with the value in the A1900 FP to determine the transmission | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| ==== Analysis line classic PPAC setup (Focus optics only) ==== | ==== Analysis line classic PPAC setup (Focus optics only) ==== | ||
| * " | * " | ||
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
