User Tools

Site Tools


tuning_the_s800_xdt

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
tuning_the_s800_xdt [2015/10/26 14:02]
pereira
tuning_the_s800_xdt [2015/10/26 14:04]
pereira
Line 235: Line 235:
           * Confirm correlations between dispersive angle at intermediate image and p in FP (e.g., crdc1x). This correlation will be somewhat washed out by straggling in the target; in principle, this should be checked without the target, but the benefit vs. cost in time to remove the target is not worth it.           * Confirm correlations between dispersive angle at intermediate image and p in FP (e.g., crdc1x). This correlation will be somewhat washed out by straggling in the target; in principle, this should be checked without the target, but the benefit vs. cost in time to remove the target is not worth it.
  
- 
- 
-==== Setup beamline ==== 
- 
-  * Object and XF scintillators and intermediate image PPACs inserted if they will be used 
-      * If Object scintillator will not be used, there is no reason to look at beam on it unless to debug a problem with the transmission 
- 
-  * Set spectrograph Brho for unreacted fragment 
- 
- 
-==== Start scalers ==== 
- 
-  * Use s800 account 
- 
-  * Make sure experiment daq is: 
-      * Stopped 
-      * Gone 
-          * Open terminal window (from bottom of mac) 
-          * ssh to spdaq20 
-          * ps auw | grep Readout 
-      * Does not get restarted 
- 
-  * Under operations folder on mac 
-      * scalers (gives error if no bridge) 
  
 ==== Setting Optimization ==== ==== Setting Optimization ====
Line 276: Line 252:
   * Document optimized transmission with another run to disk to measure rate of fragment of interest at S800 FP   * Document optimized transmission with another run to disk to measure rate of fragment of interest at S800 FP
  
- 
- 
-=== Matched optics === 
- 
-  * Typically much more time is invested for optimizing optics for matched optics than for focused optics 
- 
-  * One input is optimizing for transmission 
- 
-  * For tritons a scintillator is required at the pivot position since fragments at 5 Tm will not reach S800 FP 
- 
-  * The last two analysis line triplets are used to tweak for the desired optical properties 
- 
-  * Document optimized transmission with another run to disk to measure rate of fragment of interest at S800 FP 
  
  
tuning_the_s800_xdt.txt ยท Last modified: 2023/09/22 15:15 by swartzj