tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/26 14:19] pereira [Dispersion Matching tuning] |
tuning_the_s800_xdt [2015/10/26 15:08] pereira [Coincidences] |
||
|---|---|---|---|
| Line 333: | Line 333: | ||
| * Probably smaller typical S800 delay needed for HiRA | * Probably smaller typical S800 delay needed for HiRA | ||
| * An example of experiments where auxiliary detectors are not used and, thus, setting up coincidence timing is not an issue are the experiments with tritons run by the charge exchange group | * An example of experiments where auxiliary detectors are not used and, thus, setting up coincidence timing is not an issue are the experiments with tritons run by the charge exchange group | ||
| - | * It is not clear whether coincidence setup gets logged as “XDT” or “EXR” | + | |
| * Choice of setting to be used for coincidence timing setup | * Choice of setting to be used for coincidence timing setup | ||
| * The reaction of interest for the experiment can be used to setup coincidences only if the rate of coincidences is high enough | * The reaction of interest for the experiment can be used to setup coincidences only if the rate of coincidences is high enough | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
