tuning_the_s800_xdt
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
tuning_the_s800_xdt [2015/10/27 13:03] pereira |
tuning_the_s800_xdt [2015/10/27 14:28] pereira [Setting up Reaction Settings] |
||
|---|---|---|---|
| Line 155: | Line 155: | ||
| * They correspond to the non-dispersive position of the beam in the CRDCs. | * They correspond to the non-dispersive position of the beam in the CRDCs. | ||
| - | {{: | + | {{: |
| Line 310: | Line 310: | ||
| * Reaction setting to FP | * Reaction setting to FP | ||
| * Start with Attenuator setting of unreacted beam and step up in intensity | * Start with Attenuator setting of unreacted beam and step up in intensity | ||
| - | * Set up beam blocker, | + | * If necessary, set up beam blocker |
| + | * Click on label **I255 Slits** in the S3 page of Barney | ||
| + | * Expected " | ||
| * Expect to see unreacted beam if reaction setting is within +/- 3% of unreacted beam setting | * Expect to see unreacted beam if reaction setting is within +/- 3% of unreacted beam setting | ||
| * Should have to move only one of the two blockers unless charge states are present | * Should have to move only one of the two blockers unless charge states are present | ||
| - | * A graphic tool is available to help (not yet calibrated) | ||
| * Try to cut only as much as necessary; depends on | * Try to cut only as much as necessary; depends on | ||
| * What rate limits allow | * What rate limits allow | ||
tuning_the_s800_xdt.txt · Last modified: 2023/09/22 15:15 by swartzj
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
